Trusted ac repair for Franklin properties. Same-day service available, transparent pricing, and a workmanship guarantee.
KIC Refrigeration delivers expert air conditioning repair in Franklin, TN, diagnosing compressor failures, refrigerant leaks, frozen evaporator coils, and electrical faults using superheat, subcooling, and amp draw measurements. Our EPA Section 608 certified technicians restore rated SEER output through manufacturer-guided repair procedures across all major AC brands.
Properties throughout Franklin (pop. 91,635) face unique demands when it comes to ac repair. Tennessee heating loads, cooling calculations, and the insulation levels and duct configurations found in Franklin homes all influence the approach we take. KIC Refrigeration tailors every ac repair project to the conditions your property actually faces — no generic solutions.
Choosing the right contractor for ac repair in Franklin, TN makes all the difference between efficient comfort and a system that short-cycles. KIC Refrigeration uses Manual J load calculations, installs to manufacturer specifications, and backs every project with a warranty. Call (866) 858-2961 to schedule your free assessment.
How our NATE-certified technicians deliver quality ac repair results from start to finish.
Our Franklin technician listens to your description of the problem, inspects the thermostat settings and wiring, checks the electrical disconnect and breaker, and performs a visual inspection of the outdoor condenser and indoor air handler for obvious issues like a frozen coil, tripped safety switch, or burned wiring.
KIC Refrigeration diagnoses AC failures in Franklin, TN with precision electrical and refrigerant testing. We check capacitors within 6 percent of rated microfarads, measure contactor coil resistance, verify compressor winding resistance for shorts and opens, and test the refrigerant circuit — comparing suction pressure, discharge pressure, subcooling, and superheat to the manufacturer target values for the current outdoor ambient temperature.
We replace the failed component — capacitor, contactor, fan motor, compressor, or metering device — using parts rated for your system. For refrigerant leaks, we locate the leak, repair or replace the leaking component, evacuate, and recharge the system by weight.
Our Franklin technician verifies the repair by running the AC through a full cooling cycle. We measure supply and return air temperatures at the air handler to confirm a 16 to 22 degree split, check that suction pressure produces 35 to 45 degree evaporator saturation temperature, and verify the system cycles cleanly on and off.
Transparent answers about ac repair from our certified technicians.
AC repair in Franklin typically costs $150 to $500 for common component failures including run capacitors ($150 to $250), contactors ($150 to $350), condenser fan motors ($250 to $500), and blower motors ($300 to $600). Compressor replacement is the most expensive repair at $1,500 to $3,500 depending on unit tonnage and whether the system uses R-410A or older R-22 refrigerant. Evaporator coil replacement runs $800 to $2,500 including the refrigerant recovery and recharge. KIC Refrigeration provides a detailed written estimate with itemized parts and labor costs before beginning any AC repair at your Franklin property so there are no surprises on the invoice.
An AC that runs but produces little or no cooling is most commonly caused by low refrigerant charge from a leak, which reduces the suction pressure and causes the evaporator coil temperature to drop below 32 degrees, forming ice that blocks airflow completely. Other causes include a dirty condenser coil that cannot reject heat, a failed compressor that runs but does not pump refrigerant, a stuck or failed metering device — either a TXV or fixed orifice — that restricts refrigerant flow, or a blower motor running at reduced speed due to a failing capacitor. KIC Refrigeration connects manifold gauges at your Franklin home and measures suction pressure, discharge pressure, superheat, and subcooling to diagnose the exact cause.
AC refrigerant recharge in Franklin costs $200 to $500 for R-410A systems at roughly $50 to $80 per pound, and $400 to $1,200 for older R-22 systems at $80 to $150 per pound due to the phaseout-driven supply shortage. However, simply adding refrigerant without finding the leak is a temporary and wasteful fix — the charge will leak out again in weeks or months and you will be back in the same situation. KIC Refrigeration always locates the leak first using electronic leak detectors and UV dye, repairs the leaking component, evacuates the system to remove moisture and air, and recharges by weight to the manufacturer specification. This approach fixes the problem permanently.
KIC Refrigeration repairs every major air conditioning brand installed in Franklin homes and commercial properties — Carrier, Trane, Lennox, Rheem, Goodman, Daikin, York, Bryant, Amana, Ruud, Heil, and all other manufacturers. Our technicians hold EPA Section 608 Universal certification for refrigerant handling and are trained to work with R-410A, R-22, R-32, R-454B, and all other regulated refrigerants found in residential and light commercial systems. Whether your AC is a 2-ton window package unit or a 5-ton split system, a 20-year-old R-22 unit or a brand-new inverter model, KIC Refrigeration has the diagnostic capability and parts access to repair it correctly at your Franklin property.
Hear from property owners who chose us for their heating and cooling needs.
"Heat pump tune-up went fine. Technician was a bit late but called ahead to let me know. The actual service was thorough and professional."
"KIC Refrigeration installed our new heat pump system and the difference is incredible. Our energy bills dropped noticeably the very first month."
"KIC Refrigeration repaired our heat pump when two other companies said it needed full replacement. Saved us thousands. Still running great six months later."